All Questions

• Newest
• Hottest
• Most votes
• Most views

0 votes	974 views	1 answer	For determining the ultimate bearing capacity of soil, the recommended size of a square bearing plate to be used in load plate test should be 30 to 75 cm square with a minimum thickness of updated 9 years ago by Civil Engineer
0 votes	1530 views	1 answer	A failure wedge develops if a retaining wall updated 9 years ago by Civil Engineer
0 votes	918 views	1 answer	The change of moisture content of soils, changes the updated 9 years ago by Civil Engineer
0 votes	1006 views	1 answer	If there is no impervious boundary at the bottom of a hydraulic structure, stream lines tend to follow : updated 9 years ago by Civil Engineer
0 votes	779 views	1 answer	For general engineering purposes, soils are classified by updated 9 years ago by Civil Engineer
0 votes	774 views	1 answer	The maximum pressure which a soil can carry without shear failure, is called updated 9 years ago by Civil Engineer
0 votes	771 views	1 answer	Sedimentation analysis is based on the assumption: updated 9 years ago by Civil Engineer
0 votes	776 views	1 answer	The seepage exit gradient in a soil is the ratio of updated 9 years ago by Civil Engineer
0 votes	848 views	1 answer	The shearing force acting along the slice of a curved surface of slippage, causes the soil to slide updated 9 years ago by Civil Engineer
0 votes	775 views	1 answer	Cohesionless soil is updated 9 years ago by Civil Engineer